Introducing the Replacement Receiver Harness specifically designed for the Copperhead 10 ESC. This harness is the perfect solution to ensure seamless connectivity and reliable performance for your ESC.
Key Features:
• Equipped with the correct factory-specified connectors, ensuring a secure and proper fit.
• Includes a waterproof switch, providing enhanced protection against water and moisture.
• Built with the factory-specified wire gauge, ensuring optimal power transfer and durability.
With this Replacement Receiver Harness, you can trust that your Copperhead 10 ESC will maintain its original functionality and withstand the demands of your RC adventures.
To Remove the Receiver Harness:
1. Place slight outward pressure, with thumb, on the small tab located on outside edge of ESC case.
2. Grip the harness close to the connector at the ESC and pull gently, straight up from ESC, to remove the harness from the ESC pin header.
Note: Do not yank or forcefully pull harness out of ESC. May cause damage to ESC or harness.
To Replace the Receiver Harness:
1. Place slight outward pressure, with thumb, on the small tab located on outside edge of ESC case.
2. Following the wiring diagram provided on the side of the ESC's case, place the 5 wire connector onto the ESC pin header.
Note: Misalignment of the harness will prevent the ESC from operating. Be sure that the brown receiver wire is plugged in next to the positive (+) red battery wire.
3. Gently press on the connector to fully engage with the ESC pin header.
4. Reconnect the ESC to the receiver.
